When BROMICharge™ is added to a spa the water separates it into sodium ions and bromide ions. BROMICharge™ can be added anywhere in the spa by simply dumping it from the container. Do not breathe or get into your eyes. First Aid instructions are on the BROMICharge™ container.
- Upon initial filling your spa allow the water to circulate for one minute or so, before adding the BROMICharge™.
- BROMICharge™ is designed for use with the BROMITRON™ BROMINE GENERATOR and your warrantee will be void if another product is used as a substitute. For health purposes DO NOT USED A SUBSTITUTE! Add 1440 PPM of BROMICharge™ to the spa water. (1.2 lbs per 100 gallons) For example if the spa were 300 gallons you would add 3.6 lbs. of BROMICharge™.
- After adding the proper amount of BROMICharge™, set the BROMITRON™ BROMINE GENERATOR to its highest setting. The BROMITRON™ BROMINE GENERATOR will produce about one PPM of bromine every three hours once a bromine bank is built. The recommended bromine level is between 2-8ppm.
- When the bromine level reaches 2-5ppm and is ready for use. YOU SHOULD ALWAYS CHECK YOUR BROMINE LEVEL BEFORE USING YOUR SPA! A bromine test kit or test strips can be purchased at your spa/pool store.
- If you are having a problem producing bromine check your TDS (Totally Dissolved Solids) level to make sure your BROMICharge™ is at 1440 ppm. Purchasing a TDS meter at any spa/pool store can do this or they will check it for you. If you are adding water often, beyond what has evaporated or splashed out, then you may have a leak. If you have a leak you are not only losing water but also BROMICharge™. Leaks should be fixed immediately, due to not only the expense but also health issues that may be related to low sanitizer levels.
- If your bromine level is below 2ppm you should not enter the spa. Activate the burst mode and wait until 2ppm of bromine is present in the spa. If the bromine level is above 8ppm lower the run time. Remember your bromine generator can only produce bromine when the spa is running and your bromine generator is in the proper mode. For immediate relief of high bromine you may empty small amount spa water replacing it with fresh water until the bromine level is between 2-5ppm.
- If your spa becomes cloudy or oily due to bather load you may want to consult a spa/pool dealer for a clarifier
* BROMICharge™ is a trademarked product of the BROMITRON™ Corporation and is to be used only in the manner prescribed on the label.
continue to page 7 >>>
|
